|
| |
 |
To feed any IDS valve, choose
from our dispensing syringes, (to feed
thin to medium materials in very small shots) our
single cartridges, (for medium/thicker materials in smaller shots, beads).
For large volume
capacity, order one of our
reservoirs (for thin to medium materials) or one of our
pail dispenser units, for thicker
materials.
For a typical
setup,
click here. |
|
Also in this Category:
1 LB Pressure Pot
1 Liter Pot
2 Liter Pot
1 Gallon Pot
2 Gallon Pot
5/10 Gallon Pot
Other Valves
You may also be
interested in:
Dispensers
Valve Controller
Dispense Valves
Reservoirs
Robot
Platform
Also of interest;
Precision Needles
Needle Nozzles
Thin Wall tips
Dispensing
Help
Doming & Potting
Solder Dispensing
Solder Mask |
|
An "open top"
style (shown right,
click for larger image) is used if liners are required to prevent the material from making
contact with the sides of the container or if the fluid requires an
agitator (built into center of top lid).
The open style also lends itself to the
bulk dispensing of materials in pails, as long as they are thin enough to be
moved by air pressure (generally 40,000CPS or less) to the valve.
A ten
gallon open top tank can be fitted with a five gallon step-up for a pail,
for simple clean up. |
 |
|
|
If you are setting up in an area without air, consider our
portable air source, the Silent Benchtop
Compressor. It will generally satisfy the needs of a small benchtop
dispenser and 1 liter or 1 pound pressure pot. Consult us for larger
compressors if you need a bigger tank.
Part #
Description
7011022
10 gallon SS
Pressure pot-with open design with liners
7011023
Liner for 10
gallon tank
7011024
Gasket for Tank
Lid
7011025
10 gallon SS
Pressure pot- open with liners + agitator
|
|
| |
|
