 |
1 Liter Pressure Pot
The 1 Liter Sealed
Pressure Pot (shown left, back right) is useful for a variety of
fluids, especially UV or Light sensitive materials.
For CA, or Cyanoacrylates,
choose the One Pound Pressure Pot, (shown left,
front left) with a convenient side slit that allows operator to monitor
fluid levels without opening the top. |
|
To feed any IDS valve, choose from our
dispensing syringes, (to feed thin to medium materials in very small
shots) our single cartridges,
(for medium to thicker materials in smaller shots or beads) or for large
volume capacity, order one of our
reservoirs (for thin to medium
materials) or one of our
pail
dispenser units, for thicker materials.
For a typical valve
setup, click here.
Simple to use:
- Remove
two threaded thumbscrews and lift lid.
- Place uncapped material bottle in center of tank.
- Return lid to top of pressure tank, assuring dip tube is positioned inside
the bottle of fluid.
- Tighten thumbscrews.
- Connect all material and air lines supplying pressure to the tank.
Specifications:
Inside Dimensions:
5.25” diameter x 11.75” high
Overall Outside Dimensions:
8” diameter x 14” high
Body of Tank:
Black, solid
anodized
Aluminum
Gaskets:
(2) Teflon® encapsulated Viton® o-rings
Operating Air Pressure:
0-70 PSI
Air Inlet:
0.25” OD tube quick connect fitting
Material Outlet:
0.125” NPT polypropylene fitting
Part # Description
7011010 -
1 Liter UV Pressure Tank
7011011 - O-ring, Teflon Encapsulated Viton
for tank,2 required |
